[Mgs] circlip advise

[Clayton Kirkwood]

I can see that, but there are two ends and they don't want to be pushed
together.

 

crk

 

From: mgbob at juno.com [mailto:mgbob at juno.com] 
Sent: Monday, October 26, 2015 4:57 AM
To: crk at godblessthe.us
Cc: mgs at autox.team.net
Subject: Re: [Mgs] circlip advise

 

 A hook made from the hard metal of a paint-scraper blade works, and
tooth-scaling scrapers from your dentist or veterinarian are helpful too,
with their grippy handles and their points and angles at the scraping edge. 

Bob

 



---------- Original Message ----------
From: Clayton Kirkwood via Mgs <mgs at autox.team.net
<mailto:mgs at autox.team.net> >
To: <mgs at autox.team.net <mailto:mgs at autox.team.net> >
Subject: [Mgs] circlip advise
Date: Sun, 25 Oct 2015 21:14:12 -0700

How does one go about removing half broken circlips from u-joints? Don't
ask, you've all been there:<)) Also, I chipped the cup a little, a little
shattered; do I have to replace it absolutely or case by case. This is for
the steering u-joint. I had the carbs off and figured I might as well check
out the u-joint. Needles were dry, so needed. This is from followup on a
previous post regarding bad gas pumping and crap in the bowls and pump.

 

Pump was relatively clean, cleaned up the points. We'll see. Still have
water after draining and air compressor push out the drain. Have to replace
seals on the carb.

 

crk

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/mgs/attachments/20151026/dda7d699/attachment.html>