[Mgs] circlip advise

[Clayton Kirkwood]

How does one go about removing half broken circlips from u-joints? Don't
ask, you've all been there:<)) Also, I chipped the cup a little, a little
shattered; do I have to replace it absolutely or case by case. This is for
the steering u-joint. I had the carbs off and figured I might as well check
out the u-joint. Needles were dry, so needed. This is from followup on a
previous post regarding bad gas pumping and crap in the bowls and pump.

 

Pump was relatively clean, cleaned up the points. We'll see. Still have
water after draining and air compressor push out the drain. Have to replace
seals on the carb.

 

crk

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/mgs/attachments/20151025/a03d071e/attachment.html>