[Mgs] clutch question

[Jack Wheeler]

If you are sure the release bearing is being pushed into the clutch pressure plate the normal distance (i.e. 1/2" or so), your clutch disc could be stuck to the flywheel?  This sometimes happens when a car sits for a long time.  If this is the problem, you can usually break it loose by putting the car on a flat paved surface, and put it in gear.  While holding the clutch pedal all the way down to the floor, and your other foot on the brake pedal, start the car.  A variation on this is to start the car in gear, then while cruising along, push the clutch pedal and break pedal both at once, as hard as you can push (for the brake pedal).
Another technique is to hook a strong chain to a strong point on the frame of the MG, and get a big car (i.e. SUV) to tow it with.  Again on a flat paved surface, put the car in gear and hold the clutch pedal all the way down, then start pulling.  This will usually break it loose.  Good luck.

Jack Wheeler

      From: Mike Duvall via Mgs <mgs at autox.team.net>
 To: mgs at autox.team.net 
 Sent: Sunday, August 23, 2015 5:45 PM
 Subject: [Mgs] clutch question
   
My MGA keeps getting harder and harder to shift.  I was wondering if the synchronizers are going bad.  Lately it seems like the clutch isn’t disengaging like their was air in the lines but the hydraulics were fine.  Then no clutch at all (sitting at home instead of the road thankfully)  The slave appeared to be moving adequately so I pulled it off and I have all sorts of play in the arm.  I put a wrench on the arm and it won’t release the clutch.  I can use a flashlight and see the throw out bearing move back and forth.

I’m assuming I have a bad bearing on the arm.  Any other ideas or suggestions for me before I pull the engine? 

Thanks,  Mike


_______________________________________________

Mgs at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/mgs/jwheeler1947@yahoo.com

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/mgs/attachments/20150824/24a31dd5/attachment.html>