[Mgs] clutch slave cylinder hose

[MGBOB]

  In the dark and the dirt, this can be a hassle.  Unfasten the slave
cylinder, then access to the hose ends is a bit easier.  You might need a
Whitworth adjustable wrench for this job. Left-handed ones are best. 
Bob


 
On Wed, 17 Mar 2010 18:34:07 -0600 "Councill, David"
<dcouncill at msubillings.edu> writes:
> I am battling the infamous slave cylinder hose and it seems a 
> tighter
> fit in the Mk1 MGB (64). I am trying to remove it but am trying to
> figure out the tool I need. I lowered my largest crowfoot wrench 
> (3/4")
> to gauge the size of the nut and its too small. Does anyone know 
> the
> size wrench I need for this? And maybe the preferred tool for 
> removing
> and replacing?
> 
> 
> 
> David Councill
> 
> 64 B
> 
> 67 BGT
> 
> 72 B
____________________________________________________________
Criminal Lawyer
Criminal Lawyers - Click here.
http://thirdpartyoffers.juno.com/TGL2141/c?cp=qMv-twlqUGzT85XwYCVBFAAAJ1CFcZuYg3ZrSi-zVv-uUL-FAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAiFgAAAAA=