[Mgs] [Members2] ] mg engine

[Malcolm Jeffcock]

the clutch has less than 8k miles on it so I was just going to pop it back in. Both fly wheels look fine which is prompted the question 
  ----- Original Message ----- 
  From: Larry Yockell 
  To: Malcolm Jeffcock 
  Sent: Saturday, June 19, 2010 8:31 PM
  Subject: Re: [Members2] ] mg engine


  Hi Malcolm

  I would be only concerned about the condition of the friction surface of the flywheel and the condition of the teeth on the flywheel. 

  You are not putting a new clutch since you have the engine out?

  Larry
    ----- Original Message ----- 
    From: Malcolm Jeffcock 
    To: mgs at autox.team.net 
    Cc: members2 at batans.ca 
    Sent: Saturday, June 19, 2010 8:26 PM
    Subject: Re: [Members2] ] mg engine


    Quick question...when I put in the replacement engine should I keep the fly wheel that was on that engine before I put on the clutch or use the fly wheel off the removed anging to which the clutch had been associated?
    I suspect just keeping the engine/flywheel pairing should be preferred but just want to check... 

    Malcolm


----------------------------------------------------------------------------


    _______________________________________________
    Members2 mailing list
    Members2 at batans.ca
    http://batans.ca/mailman/listinfo/members2_batans.ca