[Mgs] [MG-MGB] LH Engine Mount

[Paul Root]

It will come out the bottom, but it's not easy.

On Jul 6, 2008, at 7:15 PM, Dan DiBiase wrote:

> Ok, I am still working on the driver's side engine mount (LHD). I  
> have come to the conclusion that I need to remove the steering shaft
> to get at it. I had purchased a bicycle wrench and could get it on  
> the nut, but I feel like it may be starting to round off a bit. So,  
> out comes
> the shaft, I guess.....
>
> Am I correct in thinking that I need can remove just the shaft, and  
> not the entire rack?? It seems like if I unbolt it at the u-joint  
> (which I have
> done and am soaking with penetrant) and then remove the cap and nut  
> at the lower end, the shaft should just slide through the rack, right?