[Mgs] LH Engine Mount

[Dan DiBiase]

Ok, I am still working on the driver's side engine mount (LHD). I have come to the conclusion that I need to remove the steering shaft
to get at it. I had purchased a bicycle wrench and could get it on the nut, but I feel like it may be starting to round off a bit. So, out comes
the shaft, I guess.....

Am I correct in thinking that I need can remove just the shaft, and not the entire rack?? It seems like if I unbolt it at the u-joint (which I have
done and am soaking with penetrant) and then remove the cap and nut at the lower end, the shaft should just slide through the rack, right?

 Dan D
Central NJ USA
'76 MGB Tourer - Driver - Engine Surgery In Progress...
'65 MGB Tourer Project - Yep, Still Is.... 
NAMGBR #5-2328 
http://dans65b.blogspot.com/
http://dansautoblog.blogspot.com/
http://mywebpages.comcast.net/dibiase/Working_MG_Gallery.html