[Mgs] MGB Clutch Problem

[Gosling, Richard]

There may be different clutch slave models out there, but on the one I
got both holes are near the bottom, neither would allow you to bleed all
the air out.  I think the one that came off was the same, but I've
chucked it out so I can't check it.


Richard & Sammy
  ________________________________________________________________________
This message (including any attachments) is confidential and may be
privileged. If you have received it by mistake please notify the sender by
return E-mail and delete this message from your system. Any unauthorised use
or dissemination of this message in whole or in part is strictly prohibited.
Please note that E-mails are susceptible to change.
The Penspen Group shall not be liable for the improper or incomplete
transmission of the information contained in this communication nor for any
delay in its receipt or damage to your system. The Penspen Group does not
guarantee that the integrity of this communication has been maintained or that
this communication is free of viruses, interceptions or interference.
The following UK companies within the Penspen Group and any electronic
communication sent on behalf of any of them, are subject to the provisions of
the UK Companies Act 1985;
PENSPEN HOLDINGS LIMITED (Company Number : 980600) Registered Office: 3 Water
Lane, Richmond, Surrey, TW9 1TJ Registered in England and Wales (VAT No; 239
7770 19)
PENSPEN LIMITED (Company Number: 584446) Registered Office: 3 Water Lane,
Richmond, Surrey, TW9 1TJ Registered in England and Wales (VAT No; 239 7770
19)
(Unipen, Penspen Integrity and Andrew Palmer & Associates are operating
divisions of Penspen Limited and Spencer & Partners and Pencol are trade names
of Penspen Limited)
MANCHESTER JETLINE LIMITED (Company Number: 2392093) Registered Office: 3
Water Lane, Richmond, Surrey, TW9 1TJ Registered in England and Wales (VAT No;
537 8635 08)