[Mg-t] Petrol Screen Filter

[Rick Lindsay]

Dan, a screen could be fabricated from bulk copper or brass screen wire, usually available at hardware stores. It has larger 'openings' but that's okay because you only want to trap the bigger stuff; the inline filter catching the fine debris. Both copper and brass can easily be soldered so you could make and install the new filter yourself at home. Hope this helps.B 

-rick
Sent from my Samsung Galaxy SIII - the rectangle with rounded corners, just like a BlackBerry.

-------- Original message --------
From: ImOZ <ImOZ at columbus.rr.com> 
Date: 09/12/2013  9:12 PM  (GMT-06:00) 
To: Mg-t at autox.team.net 
Subject: [Mg-t] Petrol Screen Filter 
 
Listers, 



Recently my TF suddenly would not start.B  After much electrical system
trouble shooting, I found there was little or no gas getting to the carbs.B  



The gas tank and fuel lines were reinstalled during restoration without the
mesh screen that protects against debris.B  In lieu of that, I cut the fuel
line and installed a modern, clear fuel filter.B  



This seemed OK until recently.B  Significant debris had accumulated in the
filter.B  Not a huge problem, I changed the filter.B  



However, no fuel would enter the line.B  I siphoned the fuel from the tank
(or most of it), and removed the fitting at the bottom of the tank.B  



By means foul or fair, a small round soft ball the consistency of rubber
cement rubbed off one's fingers had caught in the fitting exiting the tank,
blocking the flow of fuel.B  



I found several others like it when the last gush of petrol exited the tank
into my catch-pan.B  I tried cleaning the tank as best I could in situ, and
then hoped there were no more.B  



Sorry, too bad, the engine choked about 25 miles later, and had to be towed
home.B  I presume another little rubbery ball has blocked the orifice to the
fuel line.B  



I would be grateful for any advice on how to assure the tank is totally rid
of such debris.B  



But for the rest of the season, I would prefer to get a new screen brazed
onto the brass fitting, or even better, procure a fitting intact with screen
filter.B  I see that it is not available from Moss.B  



Can anyone refer me to a source for that bit, or offer advice on procuring
and fastening a substitute screen?B  I believe such an arrangement will block
any further foreign matter left in the tank until I can properly treat the
inside of the tank.B  



Thank you in advance for your advice.B  



Dan

54 TF
______________________________________________

Mg-t at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donationB  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/mg-t/richardolindsay@gmail.com