[Mg-t] TD Engine Pull

[mgbob at juno.com]

  If the leak is really bad, it indicates probable wear on the scroll and the
little shield.
  If one can tolerate quarter to half-dollar drip spots, the original seal
will do.
  In our club, six or eight owners have tried the improved seal. Half are
happy and half are not. I used the original seal type, and have no regrets.
Bob


---------- Original Message ----------
From: <wbeech at flash.net>
To: <mg-t at autox.team.net>
Subject: Re: [Mg-t] TD Engine Pull
Date: Thu, 12 Sep 2013 15:33:49 -0500

Finally getting around to the long-overdue task for replacing the rear main
on the '52TD.  What is the consensus of the list as far as the best remedy
for this repair/replacement?  I would rather not have to grind the crank to
fit some aftermarket product.  Just going to do the seals and the top-end is
tight and there are no other real issues here.

Also, as this is my first MGT engine job where is the best resource,
on-line, to go to for soup-to-nuts guidance?

Many thanks,
Bill
______________________________________________

Mg-t at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/mg-t/mgbob@juno.com