[Mg-t] TD Engine Pull

[wbeech at flash.net]

Finally getting around to the long-overdue task for replacing the rear main
on the '52TD.  What is the consensus of the list as far as the best remedy
for this repair/replacement?  I would rather not have to grind the crank to
fit some aftermarket product.  Just going to do the seals and the top-end is
tight and there are no other real issues here.
 
Also, as this is my first MGT engine job where is the best resource,
on-line, to go to for soup-to-nuts guidance?
 
Many thanks,
Bill