[Healeys] BN2 wire routing

[Michael Salter]

Thanks for those pictures Hank, unfortunately I'm still struggling with this one. There is a "P" clip large enough for both cables with a 3/16" mount hole somewhere between the headlamp and where the cables join the main harness. The only suitable fastener in the area is one of the grille mount screws but I have no recollection of ever seeing a clip on one of those. As usual I have a photo where what I need to see is just off screen.

M


________________________________
From: Hank Leach <gradea1 at charter.net>
Sent: Monday, February 16, 2026 8:04:48 PM
To: Michael Salter <michael.salter at gmail.com>; healeys at autox.team.net <healeys at autox.team.net>
Subject: RE: [Healeys] BN2 wire routing

Michael- this photo may help to show the cable routing of the harness to the connectors for the lights. Obviously taken prior to fitting the body. I would have to take a photo of the point at which the connectors come together and then to where they then travel down the fender/shroud seam to each fixture. I remember putting them in a sheath, which was difficult to find. I can't remember how its fixed. This is on an early BN1 but other than the color of the harness, about the same routing for the BN2. Hank
--------------------

From: "Michael Salter" <michael.salter at gmail.com>
To: <healeys at autox.team.net>
Sent: February 16, 2026 at 11:55 AM PST
Subject: [Healeys] BN2 wire routing
There are 2 cables with 3 wires in each which run from the side and headlights.
The sidelight set have a "P" clip which secures the side light set to the fender screw directly below the headlight.
The cables then travel together to where they join the main harness at the point where the inner fender and the radiator support bar meet.
How are the cables secured before they join the main harness.
Thanks for looking.

M



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20260217/e8f42fe6/attachment.htm>