[Healeys] PCV installation BJ8

[Bob Spidell]

Here's how my mechanic did it. Best to balance both carbs, but using the 
unused port on the manifold works OK too.  I ran that way for many 
years; the thread is some sort of Brit thread, I drilled and tapped it 
for an American one.

On 3/21/2022 10:51 AM, Michael DiVito via Healeys wrote:
> Planning to install a PCV on my BJ8 and having trouble finding the right hardware to connect to the manifold. The plug in the manifold where I will connect the PCV is 3/8” with a fine thread pattern. Does anyone know where I might purchase a suitable connector which has the correct 3/8” threaded end for the manifold connection and a 1/2” barbed end for connection to the PCV?  Also if anyone has already done a PCV install advice appreciated.
>
> Michael P. DiVito
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/bspidell@comcast.net
>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_0418.JPG
Type: image/jpeg
Size: 1349064 bytes
Desc: not available
URL: <http://autox.team.net/pipermail/healeys/attachments/20220321/45d80964/attachment.jpe>