[Healeys] Chassis outriggers.

[David Lodge]

 Hello Richard,
Thank you for that.  The best reading I can get on the harshly corroded piece is .036"!    The outside is of course perfect from all the oil sloshing over it.  The top face of the outrigger is badly corroded from the standing water blotted up by the fibre matting under the carpet.  What larks!

    On Tuesday, 12 July 2022 at 13:23:41 GMT-7, Richard J. Hockert <rjhco at att.net> wrote:  
 
 I believe that they are 16 gauge Birmingham (UK measurement). .065 inches, 1.65 mm
Does your measurement come close to this?

Best regards,Jim

On Jul 12, 2022, at 3:09 PM, David Lodge via Healeys <healeys at autox.team.net> wrote:



Greetings all!

Does anyone please happen to know the correct gauge of steel used on the BJ8 chassis outriggers?  Mine are so badly corroded on the inside that it's impossible to tell!  If I'm VERY careful I'll be able to get a pattern off them, at least!

Thanks to all.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive/healeys

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rjhco459@gmail.com


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20220714/2987a120/attachment.htm>