[Healeys] rear oil seal in tranny
Bob Spidell
bspidell at comcast.net
Wed Sep 29 07:57:14 MDT 2021
Doesn't hurt (sometimes I do, sometimes I don't). I'd use Hylomar or
something that doesn't harden or say 'adhesive;' could make it very hard
to remove (hopefully, not necessary--again). Very thin film only, most
of it will get pushed out anyway.
On 9/29/2021 5:08 AM, Tom Felts via Healeys wrote:
> May have mentioned before---but anyway----had BJ8 tranny and OD
> rebuilt----supposedly a new oil seal was installed in the rear drive
> shaft. Added oil. It leaked out of the back of the seal. Pulled
> nut, removed seal. now waiting for new seal. when I put it back,
> should I use a smear of Permatex around rear of oil seal and on the
> splines if the drive shaft?
>
> BTW--I'm doing this while the tranny is installed.
>
> Thanks Tom
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210929/9fc2ccc6/attachment.htm>
More information about the Healeys
mailing list