[Healeys] tranny installation--BJ8

[David P]

A light coat of oil on the splines aids the insertion.. after that it 
requires muscle for the first 1" to get parallelism of the splines... 
Muscle.

On 9/21/2021 3:34 PM, Bob Spidell wrote:
> I've done this a few times;  IIRC it always takes a bit of fiddling to 
> get them to mate up. How far out is it; an inch or so the first motion 
> shaft is probably butting-up against the spigot bearing, any more and 
> you might be facing the same issue Simon said he had?
>
> On 9/21/2021 2:18 PM, richard mayor via Healeys wrote:
>> Can you be more specific?   Not sure why you even have the shifter 
>> still attached.  It can poke you in the eye.   You just need to make 
>> sure the tranny is in one of the gears so you can rotate the output 
>> shaft if necessary to make the input shaft splines mate with the 
>> clutch splines.
>>
>> On Tue, Sep 21, 2021 at 1:11 PM Tom Felts via Healeys 
>> <healeys at autox.team.net <mailto:healeys at autox.team.net>> wrote:
>>
>>     Try as two of us can, we could not get the tranny back in the
>>     car. Is there a specific position it has to be to mate?  I heard
>>     the shifter at about the 10 oclock position but that didn't seem
>>     to work.
>>
>>
>>
>>     tom
>>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/frogeye@porterscustom.com
>
-- 
Porter Custom Bicycles 2909 Arno St. NE Albuquerque, NM. 505-352-1378 My World go here: WWW.PORTERBIKES.COM/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210921/a454ac02/attachment.htm>