[Healeys] Dashboard signal indicator

[John Spaur]

No issues with the wiring. I properly installed a new wiring harness and
flasher can in 2013. It has worked properly for 6,000 miles. It lights up
when I flip the steering wheel switch and stays lit up.

-----Original Message-----
From: sentenac.rw at gmail.com [mailto:sentenac.rw at gmail.com] 
Sent: Monday, May 24, 2021 8:30 PM
To: John Spaur <jmsdarch at sbcglobal.net>
Cc: 'healeys' <healeys at autox.team.net>
Subject: Re: [Healeys] Dashboard signal indicator

does the indicator light up when the turn signal lights or does it light up
when the turn signal is off (that is, between flashes)? Since the indicator
doesn't flash, but only goes on, you will have to observe the indicator and
the turn signal light simultaneously during the first flash cycle to check
this.

Why bother?  Well, because if the indicator is in parallel with the turn
signal lights then both should flash of one flashes unless something strange
is happening.  If the indicator runs off of another terminal on the flasher
and it isn't flashing, perhaps the flasher unit is in an early failure mode
and it is time to replace it.

It would be good to stare at the wiring diagram, too, and hope that your
wiring hasn't been 'improved' by someone in the past.  If you can trust the
wiring diagram you can sort things out a lot easier.

-Roland
BN1

On Mon, 24 May 2021 18:31:02 -0700, you wrote:

>RE: BT7 signal issue.
> 
>When I use the signal for a right or left turn, the indicator lights up 
>to a bright solid green instead of blinking. It will stay that way for 
>a few seconds and then revert to off.
> 
>All lights are functioning. The signals blink right or left and the 
>brake lights work. I can hear the flasher working too.
> 
>Any ideas as to what is wrong?
> 
>TIA
>John
>'62 BT7

--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus