[Healeys] Washers for Rubber Buffers?
Jean Caron
vintage_roadster_restoration at hotmail.com
Sun Jul 25 13:06:15 MDT 2021
The washers are made of steel.
Jean
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
From: Harold Manifold via Healeys<mailto:healeys at autox.team.net>
Sent: July 25, 2021 1:40 PM
To: Ken Fleming via Healeys<mailto:healeys at autox.team.net>
Subject: [Healeys] Washers for Rubber Buffers?
Hello,
I am getting ready to install the rubber fender and hood buffers. I have copper split rivets but what material should the washers be? These are quite visible when the hood is opened so I would like to get it right. All of the original washers used on my 1960 BT7 were zinc plated steel but I have read the washers should be copper.
The attached picture is one of the fender buffers but I assume all of the washers should be the same.
I would appreciate any advise for my car.
Harold
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210725/3049b585/attachment.htm>
More information about the Healeys
mailing list