[Healeys] Wiper Motor Bushings

[richard mayor]

Here's my experience trying to get those rock hard bushings into the holes
on my BT7.  First, no amount of lube will allow it to happen.  I asked this
same question on this forum about 2 years ago.  Got many of the same
response - lots of lube, yada yada yada.  Finally, one poster gave me the
solution.  Slice them open on one side.  But, make the cut at an angle -
not parallel to the hole.  This way you can screw them into the mounting
hole. Using some lube will also help. I recommend K-Y jelly.

On Tue, Feb 16, 2021 at 9:12 PM Michael MacLean via Healeys <
healeys at autox.team.net> wrote:

> Can someone tell me how to get those humongous rubber bushings in place
> for my BN2 wiper motor?  I did it for the Bugeye 20+ years ago, but for the
> life of me I can't remember how I did it.
> Mike MacLean
>
> Sent from AT&T Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/boyracer466@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210217/2679a2dd/attachment.htm>