[Healeys] Fasteners and Air Intake Stuff

[Curtis Arndt]

Both of the master cylinder mounting bolts on most (most likely all) BN1s
and definitely all BN2s were UNF.  You may have to run a 5/16 UNF tap into
the holes to clean them out.

On Thu, Nov 5, 2020 at 9:52 PM Michael MacLean via Healeys <
healeys at autox.team.net> wrote:

> Healey 100 listers,
>      Can someone please confirm to me that the mounting bolts for the
> master cylinder on a BN1/2 is BSF threads or UNF.  I started to thread in a
> UNF bolt to mount the master cylinder and the familiar one turn and then
> stop when I am using the wrong thread on this car appeared.  I firmly
> believe if it's hard to do, you are doing it wrong.  Also, can someone
> confirm the horizontal part of the split air director that mounts behind
> the radiator grill is attached with two of the screws for the bumper
> apron?  I see no other attachment points other than the top of the air
> director vertical panel after it is bolted to the horizontal panel.  Where
> is the top attachment point on the body for the vertical panel?  This would
> be much easier if I had someone's BN1/2 to look at during assembly, but I
> am on my own pretty much relying on pictures I can find on the internet.
> Mike MacLean
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/cnaarndt@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20201106/6198d778/attachment.htm>