[Healeys] Fasteners Again
healey.nut at gmail.com
Sun Dec 27 01:32:41 MST 2020
To clarify, originally there was a set screw (i.e., a fully threaded hex
bolt) there to be the final tighten for the bracket.....
On Sun, Dec 27, 2020 at 4:25 PM Alan Seigrist <healey.nut at gmail.com> wrote:
> Hi Michael -
> If threaded, that hole should be either 5/16ths BSF or 3/8ths BSF. I will
> have to check.
> Best Regards,
> On Sun, Dec 27, 2020 at 8:27 AM Michael MacLean <rrengineer.mike at att.net>
>> Can someone tell me the fastener arrangement for this hole in the
>> generator front plate of my BN2? From some pictures I see on the web there
>> is a nut on the backside of the generator plate. Why then is the hole
>> threaded? (and it's not UNF) What thread/size fastener and/or nut do I
>> Mike MacLean
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/pipermail/healeys
>> Healeys at autox.team.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Healeys