[Healeys] Head Gasket?

[Michael MacLean]

 I have no idea if it is a Payen gasket or not.  Heck it's been sitting in a package of engine gaskets for so long I'm not even sure if I bought it several years ago or it was given to me by the guy that built the short block.  Just trying to identify it.  If it is a Payen then I would have no problem using it.  Just don't know what it is.Mike M

    On Saturday, April 18, 2020, 10:52:07 PM PDT, Bob Spidell <bspidell at comcast.net> wrote:  
 
  If it's an older (English made) Payen and all the holes line up it should be fine for a stock engine with iron head.  We used one in our BN2 rebuild years ago, and it has caused no problems (but the car has probably been driven less than a thousand miles).  Make sure the block and head faces are flat or no gasket will work.
 
 Bob
 
 On 4/18/2020 9:55 PM, Michael MacLean wrote:
  
 
In the process of putting the head on my 100 engine.  I have a head gasket, but not sure what I have or if it is a good one.  It is copper faced on both sides.  There is no "TOP" marking.  All it has is G-2012F on one side stamped about in the middle almost between the 2 and 3 cylinders. This gasket OK to use? 
  
 
 
  
 _______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rrengineer.mike@att.net

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200419/bd3203e5/attachment.htm>