[Healeys] Fwd: Hi Randy, I am stumped. michael.

[Michael Salter]

Hi Michael,
The threads in the block are BSF. I can't remember if they are 3/8" or 7/16
but can check for sure whan I get back from Deadwood on Monday.
BTW if you are intending to assemble the engine on a stand might I suggest
considering mounting onto the side of the block ... it makes assembly much
easier.

M

On Wed, Sep 11, 2019, 3:59 PM Randy Hicks via Healeys, <
healeys at autox.team.net> wrote:

> Received this from a friend. Can anyone help out?
>
> Randy
>
> Begin forwarded message:
>
> *From: *michael mc burney <mcb.1 at comcast.net>
> *Subject: **RE: Hi Randy, I am stumped. michael.*
> *Date: *September 11, 2019 at 4:54:14 PM EDT
> *To: *Randy Hicks <randyhicks at me.com>
>
>
>     Hello Randy, Hate to bother but I am stumped over a simple fastener
> problem. I am attempting to mount
>     my spare BN2 block onto a engine stand. Problem is with the four
> fasteners needed to do this. I have tried
>     all the bolts I think should work, but no! I thought the engine
> plate/xmission, bell housing used 3/8 by 24.
>     The cap screws will thread into the block but will not tighten. Do
> you/or one in the healey nation/ happen to
>     know the proper cap screw/bolt that will do the trick???
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20190911/a243bd94/attachment.html>