[Healeys] Getting engine mounts in line.

Kees Oudesluijs coudesluijs at chello.nl
Fri May 31 04:02:14 MDT 2019

Usually lifting the engine slightly (crane, be very wary using a jack 
under the sump!!) will allow enough manoeuvring space to fit the 
bolts/mounts/nuts with most cars/engines. You may have to use a tyre 
lifter bar to ease the rubber mounts in place.

Kees Oudesluijs

Op 31-5-2019 om 10:48 schreef simon.lachlan at alexarevel.plus.com:
> Hi,
> I’ve been messing around with the front end of my 3000 so I’ve had to 
> detach the engine mounts by removing the vertical bolts. Now that I’m 
> trying to get the mounts reattached, I’m having a hell of a job to get 
> the holes to line up. I’ve loosened off the bolts that attach the 
> mounts to the engine, but there’s still about half an inch here, there 
> and everywhere to contend with.
> Is there a knack to this job? I can see myself expending a lot of 
> brute force and ignorance here….
> Simon
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20190531/037df7eb/attachment.html>

More information about the Healeys mailing list