[Healeys] Fwd: BT7 Mk II Door Shut Finisher - Adjustment?

[Per Schoerner]

Dan
Did you see this? Go to David Nock, probably Kilmartin can make them a little oversize for a BT7 as well, although it’s not in their catalog.

Per

Skickat från min iPhone

Vidarebefordrat brev:

> Från: "David Nock BCS" <healeydoc at sbcglobal.net>
> Datum: 13 februari 2018 17:53:00 CET
> Till: "Linwood Rose" <linwoodrose at mac.com>, "Per Schoerner" <per at schoerner.se>
> Kopia: <healeys at autox.team.net>
> Ämne: Re: [Healeys] BT7 Mk II Door Shut Finisher - Adjustment?
> 
> The shut pillar trim that has come out of England has never fit the car correctly. We have used and supplied the ones the come from Kilmartin in Australia for many years and they always fit. They usually are a little big so they can be trimmed to fit your car.
>  
>  
> David Nock
> British Car Specialists
> 209-948-8767
> www.britishcarspecialists.com
>  
> From: Linwood Rose
> Sent: Monday, February 12, 2018 5:01 PM
> To: Per Schoerner
> Cc: healeys at autox.team.net
> Subject: Re: [Healeys] BT7 Mk II Door Shut Finisher - Adjustment?
>  
> As I recall, and I could be wrong because it was ten years ago, I had the same situation. The ill fitting set was from one of the usual vendors. I believe I ordered a set from Kilmartin and they were spot on. Check with Kilmartin and see if they sell them. 
> Lin
> 
> Sent from my iPad
> 
>> On Feb 12, 2018, at 5:23 PM, Per Schoerner <per at schoerner.se> wrote:
>> 
>> Dan
>> It looks like the shut panel can go a little bit further towards the center of the car, there is a gap there. On the other hand it doesn’t look like it will fit anyway. Do you still have the originals? So you can compare them.
>>  
>> Per
>> 
>> Skickat från min iPhone
>> 
>>> 12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com>:
>>> 
>>> Everything was going very smoothly installing the new Bristleflex door seals and lower aluminum trim set.  Too smoothly…
>>>  
>>> A trial fit of the door shut finish set revealed the protrusion on the top is misaligned.  Anyone experienced this before?
>>>  
>>> (The dotted line suggests what I’m thinking about)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20180213/af9722bf/attachment.html>