[Healeys] BT7 Mk II Door Shut Finisher - Adjustment?

[Linwood Rose]

As I recall, and I could be wrong because it was ten years ago, I had the same situation. The ill fitting set was from one of the usual vendors. I believe I ordered a set from Kilmartin and they were spot on. Check with Kilmartin and see if they sell them. 
Lin

Sent from my iPad

> On Feb 12, 2018, at 5:23 PM, Per Schoerner <per at schoerner.se> wrote:
> 
> Dan
> It looks like the shut panel can go a little bit further towards the center of the car, there is a gap there. On the other hand it doesn’t look like it will fit anyway. Do you still have the originals? So you can compare them.
> 
> Per
> 
> Skickat från min iPhone
> 
>> 12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com>:
>> 
>> Everything was going very smoothly installing the new Bristleflex door seals and lower aluminum trim set.  Too smoothly…
>>  
>> A trial fit of the door shut finish set revealed the protrusion on the top is misaligned.  Anyone experienced this before?
>>  
>> (The dotted line suggests what I’m thinking about)
>>  
>> <IMG_0333.JPG>
>> Best,
>> 
>> Dan Corning
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/linwoodrose@mac.com
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20180212/4a985b31/attachment.html>