[Healeys] clutch hydraulics question

i erbs eyera3000 at gmail.com
Fri Aug 24 19:18:23 MDT 2018

I think the throw out bearing pushes back on fulcrum arm and that pushes
piston forward. I need to lengthen the fulcrum point on my smitty 5 speed
system so the clutch engages higher up. Some day I will.

Ira Erbs
Portland, OR
typos and artifacts are the fault of my phone

On Fri, Aug 24, 2018, 5:15 PM Bob Haskell <rchaskell at earthlink.net> wrote:

> Listers,
> If the clutch lever arm is disconnected from the slave cylinder push rod
> and the clutch pedal is pressed to the floor, the push rod is pushed to
> towards the rear of the car.  When the clutch pedal is released should
> the suction created in the hydraulic system pull the slave cylinder
> piston back in?  Or does the system rely on just the pressure plate
> springs to move the release bearing/lever arm/rod/piston back?
> Cheers,
> Bob Haskell
> AHCA 3000 MkI registrar
> http://www.ciahc.org/registry_3000mk1.php
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/pipermail/healeys
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20180824/48263a18/attachment.html>

More information about the Healeys mailing list