[Healeys] Differential Locked

[Michael MacLean]

I'll use that method when I re-install the pumpkin when I figure out the problem. Thanks Dave.Mike MacLean

Sent from Yahoo Mail on Android 
 
  On Wed, Sep 27, 2017 at 6:26 PM, David Nock<healeydoc at sbcglobal.net> wrote:   Paper gaskets commonly shrink. Soak in water for a few minutes prior to installing 

Sent from my iPhone
On Sep 27, 2017, at 5:11 PM, Michael MacLean <rrengineer.mike at att.net> wrote:


Finally installed the pumpkin in the newly painted differential case today.  Used Hylomar to seal it.  The paper gasket from Moss did not fit very well.  I needed to use my single hole paper punch to get it to fit.  Tightened it down and now the output flange is locked in place.  It moves back and forth a fraction of an inch but stops with a decided metallic clunk.  No, I did not install it upside down.  That actually can not be done the way the ring gear is "keyed" into the casing.  What the heck?Mike MacLean


_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/healeydoc@sbcglobal.net


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170928/33a08ea0/attachment.html>