[Healeys] Replace seal in speedo adapter

Per Schoerner per at schoerner.se
Sun Dec 24 03:43:22 MST 2017


Bob
You have to brake the pin off, that’s the only way to get it apart. Just twist it till the pin brakes, then screw it apart, the parts are threaded. The threads will be a little damaged, but not more than that they can be used again. Don’t bother to replace the pin, you can use some thread locker instead.
But as someone said, if it ain’t broke.....

Per

Skickat från min iPhone

> 23 dec. 2017 kl. 22:22 skrev Bob Spidell <bspidell at comcast.net>:
> 
> Merry Christmas--or whatever!--Listers.
> 
> 
> 
> I have my speedo adapter out on the bench and figured it would be a good time to replace the O-ring and seal; however, the seal is buried inside the adapter and it too big to be replaced in the usual fashion.  It appears the adapter is a 2-piece unit, with a smaller part--with the threads for the angle drive--inside the 'barrel.'  It should come apart, but for a small pin that holds the parts together (see attached photo).  Anybody know how to separate the two; hopefully, so they can be rejoined?
> 
> 
> 
> TIA,
> 
> Bob
> 
> --------------------------------
> Bob Spidell - San Jose, CA
> 
> <SpeedoDrive.JPG>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/per@schoerner.se
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20171224/69f72e47/attachment.html>


More information about the Healeys mailing list