[Healeys] Knock off hammer - aftermarket

[HealeyRick]

I go for the six pounder in case the KO needs some additional persuading.
They'll recast it once it gets too bunged up:
http://americanhammer.com/lead-hammer/

On Sat, Aug 12, 2017 at 6:56 PM, Bob Spidell <bspidell at comcast.net> wrote:

> "What do people think about a 32 once rubber mallet ..."
>
> I think the hammer will bounce off the knockoff and smite thee in the
> face.  I haven't tried a dead blow, but in a pinch I used a softwood block
> and a small sledgehammer to tighten a knockoff, and it flattened and marred
> the ear of the knockoff, and I think a dead blow might do the same.
>
> I'd stick with lead hammers (copper may be OK, but I haven't used one and
> I believe copper is a bit harder than lead).
>
> Bob
>
> On 8/12/2017 2:45 PM, John Spaur wrote:
>
> What do people think about a 32 once rubber mallet versus a 45 once
> polyurethane dead blow hammer for removing knockoffs?
>
>
>
> John Spaur
>
> San Jose
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/healeys/healeyrik at gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170812/b1d1ca5c/attachment.html>