[Healeys] Oilite(?) pilot (spigot) bushing
Oudesluys
coudesluijs at chello.nl
Mon Aug 15 08:19:55 MDT 2016
Consider it a sinter bronze bush. If it is not no harm will be done.
Immerse the bush in a cup of oil and put bearing in cup in the oven at
130 degrees C for about an hour. Then let it cool down completely before
you take out the bush. During heating up air will be expelled from the
bronze bush, during cooling down oil will be drawn in.
Kees Oudesluijs
Op 15-8-2016 om 15:53 schreef Bob Spidell:
> I'm getting ready to do an engine rebuild and replace the clutch on my
> BJ8. Bought a new pilot/spigot bush from Moss, but I seem to recall
> the ones I've seen before had small dark spots that I assumed were
> from the oil that is impregnated into the bronze. The new one
> appears to be just bronze; are these (still) 'Olilite' bushings? If
> so, are they supposed to be soaked in oil before installation?
>
> TIA,
> Bob
>
> --------------------------------
> Bob Spidell - San Jose, CA
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20160815/b0dc17a5/attachment.html>
More information about the Healeys
mailing list