[Healeys] Throttle shaft rebush

[Tim Davis BN7]

That is close but I need something in addition to that. Do you recall if the clutch was in place? 


----- Original Message -----

From: "richard mayor" <boyracer466 at gmail.com> 
To: "Tim Davis BN7" <tld6008 at mchsi.com> 
Cc: "Healey List" <healeys at autox.team.net> 
Sent: Saturday, October 10, 2015 3:27:29 PM 
Subject: Re: [Healeys] Throttle shaft rebush 

I seem to recall using a 1/4" drive socket to get to the back bolts. 

On Sat, Oct 10, 2015 at 9:36 AM, Tim Davis BN7 < tld6008 at mchsi.com > wrote: 



There was a tech article in the May 2006 issue of Austin Healey magazine where Norman Nock described the wear points in the 3000 throttle linkages and briefly discusses removing and replacing them. Specific to my situation is where he describes the replacing of the bushes on the 15" cross-shaft above the bellhousing. Also for added convinience he suggests removing the transmission cover. And then work the right bracket from under the bonnet and from below the car on the left side. 
I am attempting to do this since I have my transmission out but for the life of me can't remove the rear bolt on each bracket. I have yet to remove the clutch which would gain me more access and I can't get under my car. I know this can be done but I need a few hints..Please!! 

Tim Davis BN7 


_______________________________________________ 
Support Team.Net http://www.team.net/donate.html 
Suggested annual donation $12.75 
Archive: http://www.team.net/archive 
Forums: http://www.team.net/forums 

Healeys at autox.team.net 
http://autox.team.net/mailman/listinfo/healeys 

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/boyracer466@gmail.com 







-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20151010/5cba70a0/attachment.html>