[Healeys] Throttle shaft rebush

richard mayor boyracer466 at gmail.com
Sat Oct 10 14:27:29 MDT 2015


I seem to recall using a 1/4" drive socket to get to the back bolts.

On Sat, Oct 10, 2015 at 9:36 AM, Tim Davis BN7 <tld6008 at mchsi.com> wrote:

> There was a tech article in the May 2006 issue of Austin Healey magazine
> where Norman Nock described the wear points in the 3000 throttle linkages
> and briefly discusses removing and replacing them. Specific to my situation
> is where he describes  the replacing of the bushes on the 15" cross-shaft
> above the bellhousing. Also for added convinience he suggests removing the
> transmission cover. And then work the right bracket from under the bonnet
> and from below the car on the left side.
> I am attempting to do this since I have my transmission out but for the
> life of me can't remove the rear bolt on each bracket. I have yet to remove
> the clutch which would gain me more access and I can't get under my car. I
> know this can be done but I need a few hints..Please!!
>
> Tim Davis BN7
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/boyracer466@gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20151010/aaae5363/attachment.html>


More information about the Healeys mailing list