[Healeys] BN1 rear brake cylinder

[Oudesluys]

Keep everything clean and lightly lubed, taking care not to get any 
grease/oil on the brake linings, and it should not be any problem. It is 
not moving about constantly, it just needs to move when it is 
centralising during adjustment.
Kees Oudesluijs


Jim Richmond schreef op 17-3-2015 om 1:48:
> The rear slave cylinder is supposed to "float".  With the backing plate off the car, how easily should it slide?  Locking plates from Moss are slightly thicker than the originals.  (.012)  It takes a bit of force to move it.  Will this be a problem?
>
> Jim Richmond
>
> Sent from my iPad
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2015.0.5751 / Virusdatabase: 4306/9317 - datum van uitgifte: 03/16/15
>
>