[Healeys] BN1 Clutch Return Spring Anchor

[Michael]

Gosh....I never thought of that. 😁 

-----Original Message-----
From: "Oudesluys" <coudesluijs at chello.nl>
Sent: ‎15/‎06/‎2015 4:38 p.m.
To: "healeys at autox.team.net" <healeys at autox.team.net>
Subject: Re: [Healeys] BN1 Clutch Return Spring Anchor

The exact dimensions don't seem to be very critical. Make sure it fits snugly on the flange at the rear. It should be very easy to make one up using a hacksaw, grinding stone and a good drill. The bracket should be strong enough so a thickness of 3mm will do. As long as the spring does not touch any adjacent parts all should be well.
Kees Oudesluijs


Michael Salter schreef op 15-6-2015 om 20:44:

I have been unable to find the clutch return spring anchor for #174. 

Looks as though I'm going to have to make one.

I have attached a pic of one in position but do not have enough information to make one..

Can anyone out there send me a picture of one removed.. perhaps dimensions too.

Thanks,


Michael S

BN1 #174


-- 

If you can't fix it with a hammer, you've got an electrical problem.



 

_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl


 

Geen virus gevonden in dit bericht.
Gecontroleerd door AVG - www.avg.com
Versie: 2015.0.5961 / Virusdatabase: 4360/10019 - datum van uitgifte: 06/15/15
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150615/8f53e0b0/attachment.html>