[Healeys] BN1 Clutch Return Spring Anchor

[Oudesluys]

The exact dimensions don't seem to be very critical. Make sure it fits 
snugly on the flange at the rear. It should be very easy to make one up 
using a hacksaw, grinding stone and a good drill. The bracket should be 
strong enough so a thickness of 3mm will do. As long as the spring does 
not touch any adjacent parts all should be well.
Kees Oudesluijs


Michael Salter schreef op 15-6-2015 om 20:44:
> I have been unable to find the clutch return spring anchor for #174.
> Looks as though I'm going to have to make one.
> I have attached a pic of one in position but do not have enough 
> information to make one..
> Can anyone out there send me a picture of one removed.. perhaps 
> dimensions too.
> Thanks,
>
> Michael S
> BN1 #174
>
> -- 
> /If you can't fix it with a hammer, you've got an electrical problem./
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com <http://www.avg.com>
> Versie: 2015.0.5961 / Virusdatabase: 4360/10019 - datum van uitgifte: 
> 06/15/15
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150615/ce57ab43/attachment.html>