[Healeys] unknown valve cover
Michael Oritt
michael.oritt at gmail.com
Sat Jun 13 16:04:56 MDT 2015
Ken--
Wish I had seen your post earlier when I was over at my shop. I have an
Elva Courier which has an MGA engine and could have measured for you (MGA's
and B's heads are the same size).
I did find this online at the MG Experience where someone was asking the
same question in similar circumstances:
Center to center on the holes 11"
4 3/4" wide at base
14 7/8" long at base
3 1/2" high at center add 3/4" for filler neck
I thought that 12-3/4 seemed a bit small. Perhaps it is for a Triumph
Spitfire or the like.
Best--Michael Oritt
On Sat, Jun 13, 2015 at 2:43 PM, <goldengt at cal.net> wrote:
> I got one of the finned coffin style valve covers at the swap meet like
> used on the Hollywood Sport Car racer. The seller said it was for a Sprite
> so I thought cool, I can get it for my sister to match mine on the 3000.
> Well it doesn't fit a Sprite valve cover gasket so I suspect it might be
> for a MGB. Its outside dimensions are 4 x 12 3/4 inches. Any ideas?
> Thanks,
> Ken Freese
> 65 BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michael.oritt@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150613/1f4b2388/attachment.html>
More information about the Healeys
mailing list