[Healeys] brake servo dismantling

goldengt at cal.net goldengt at cal.net
Wed Jul 22 19:59:23 MDT 2015


It looks like the guy on the video did what I was contemplating. Drill a partial hole in the plug for a screw to pull it out.Thanks,Ken
----- Original Message -----
From: john doe <rccpl1 at yahoo.com>
To: goldengt at cal.net
Sent: Tue, 21 Jul 2015 17:48:33 -0700 (PDT)
Subject: Re: [Healeys] brake servo dismantling

There is a video on YouTube that shows the rebuild  it's a step-by-step procedure 




Sent from Yahoo Mail on AndroidFrom:"goldengt at cal.net" <goldengt at cal.net>
Date:Tue, Jul 21, 2015 at 8:26 PM
Subject:[Healeys] brake servo dismantling

I have been saving an old BJ8 servo to rebuild for many years. I have
 gotten the main bore seals out and it looks ok, but I cannot not get the control valve piston plug out of the body to get access to the control valve seals. The instructions say use some stiff wire to push it out, but it isn't budging. Should I just assume this is an indicator of sufficient corrosion to scrap the whole unit?Ken Freese65 BJ8
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150722/61e32d3c/attachment.html>


More information about the Healeys mailing list