[Healeys] Front Hub Bearing

[Tim Davis BN7]

Get a large diameter drift at least 1/2" end and make sure it has a good squared off edge. Norman Nock gave me this recommendation years ago I I have not had a problem since.

Tim Davis BN7

----- Original Message -----
From: "Elton Schulz" <eschulz at frontiernet.net>
To: "Healey List" <healeys at autox.team.net>
Sent: Sunday, March 23, 2014 10:41:02 PM GMT -06:00 US/Canada Central
Subject: [Healeys] Front Hub Bearing

Fellow Listers,
I'm replacing my front hubs on my BJ7. The old bearings look good. 
However I can't figure out how to remove the outer race of the inner 
bearing. There is insufficient lip of the outer race to drift it out to 
the back of the hub. Any ideas?
Thanks,
Elton
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/tld6008@mchsi.com