[Healeys] Fender Beading

[Bob Spidell]

Good idea.  I think you could fold the tape over the entire tab and leave it on.

Bob

On 6/30/2014 6:23 PM, Michael wrote:
> Hi Stephen,
> The only things that I would add to Paul's procedure is that folding a piece
> of insulation tape over the end of each tab will prevent it from scratching
> the paint.
> Also as you tighten bolts the be careful not to pull the fender in with the
> beading too low in the gap. If you get it wrong the beading can break a chip
> out of the paint as the gap close.
> Michael S
> BN1 #174
>
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************