[Healeys] Start up after rebuild

[Chris Dimmock]

Aside from all the good advice you have already been given, I'd check the
earth strap. Take it off the chassis, grind the nice fresh paint off, clean
the paint out of the thread, and refit. Some of that conductive grease is
always good....
Then see if it starts and runs.
My engine was effectively earthing via the accelerator cable...
Best
Chris

Sent from my iPhone

> On 6 Jan 2014, at 12:58 pm, Simon Atkinson <satkinson1974 at gmail.com> wrote:
>
> Tried to start her up after 10yrs today and a complete rebuild. No go....
> Here's what's happening and could use some help...
>
> Have oil pressure
> I think timing was set good to TDC
> Engine turns and tries to start
> Getting some smoke from air cleaners
> Little back firing from exhaust
> Starter turns and then spins after either 3 or 6 seconds (max).
> Have fully charged battery
>
>
> Starter issue?
> Timing issue?
> Carbs fuel/air mixture issue?
>
> Any advice (sorry I know hard to troubleshoot from a far) would be
> appreciated!
>
> Thanks,
> Simon
> Cell 860-324-0248
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/austin.healey@gmail.com