[Healeys] Lempert 3.54 gears install

[Bob Spidell]

Also, you'll need new gaskets and possibly O-rings for the axle/hubs. 

----- Original Message -----



You'll need to fit a new seal when you reinstall the diff. Be sure to set the outside edge of the seal even with the inside edge of the bevel at the flange end. 

Torque spec is quite high--140 or 150lb-ft IIRC--so you'll need a torque wrench with that range. 

Bob 

----- Original Message ----- 



Yep, Kees is absolutely correct. Not a first time project. You'll need a 
couple dial indicators and holders, likely shims and the knowledge to 
correctly align the meshing of the gears.. all critical to quiet running and 
long life.. 
dave 
frogeye at porterscustom.com 

Porter Customs 2909 Arno NE 
Albuquerque, NM USA 87107 
505-352-1378 
Porter Custom Bicycles 

gallery: 
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff 

GO HERE: http://porterbikes.com/ nice pictures-fun facts-my world