[Healeys] motor mounts again

[Jim Werner]

Sorry, that tech tip was for throttle linkage, not motor mounts!!!   Wrong
thread.


Jim Werner



-----Original Message-----
From: Jim Werner <jwhlyadv at aol.com>
To: goldengt <goldengt at cal.net>; healeys <healeys at autox.team.net>
Sent: Thu, Apr 17, 2014 4:35 pm
Subject: Re: [Healeys] motor mounts again


I remember a Tech Tip to replace the bolts with allen head bolts and it made
reassembly easier. Has anyone tried that?


Jim Werner



-----Original Message-----
From: goldengt <goldengt at cal.net>
To: healeys <healeys at autox.team.net>
Sent: Thu, Apr 17, 2014 1:14 pm
Subject: [Healeys] motor mounts again


I see via the archive listings that the topic has been covered, but I can't
open
any of the archive links. I put the engine in last week and purposely
switched
the mounts because of rubber was a little cracked on the exhaust side. I see
now
that the plate between the rubber and the engine block is handed. Will the
motor
be in the same place regardless of the plate, AEC889 or AEC890 used? I don't
really care about shimming issues that might be related. The trans mounts fit
ok. Otherwise I plan to start er up today.
Ken Freese
65 BJ8
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jwhlyadv@aol.com
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jwhlyadv@aol.com