[Healeys] Bump stops

[john spaur]

Ok, I presume the car is properly supported on jack stands and you 
have removed the wheel.

Support the bottom of the spring plate with a jack just enough to 
take the weight off of the coil spring. It will lift the car off of 
the jack stand but you can insert a shim to take up the distance. 
Remember to be careful.

Unbolt the shock arm from the king pin. Loosen or remove the shock 
bolts so you can access and remove the bolt under the shock. Assembly 
is the reverse of disassembly.

You may only need to loosen the shock enough to remove the offending 
bolt and you may not need to unbolt the shock arm from the king pin; 
I can't recall if you can get enough clearance by just loosening the 
shock mounting bolts.

I know the king pin installation procedure calls for a 2" distance 
piece under the shock arm but that is only needed when you are 
replacing the lower A-arm bushings.

John Spaur
'62 BT7