[Healeys] BJ8 Carbs -- Install together or separately?

Tom Felts tomfelts at windstream.net
Mon Nov 26 18:42:12 MST 2012


just did this to replace a jet assy.  I removed them together till they clear the studs--then the center section of the linkage cpmes out and suddenly you have separate carrs.  go back the same way----kinda ease the linkage in the slots while sliding the carbs over the studs together.  

Do not disasemble the linkage--you don't need to.

tom

---- Greg Mandas <gmandas at yahoo.com> wrote: 

=============
Do "You" remove/install the carbs on a BJ8 together as one unit or separately?

I do them together, but it's a bit difficult to get to the two bolts under the rear carb.

I'm assuming to replace them separately, you'd have to disassemble the linkage and reset it afterwards.

Greg
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/tomfelts@windstream.net


More information about the Healeys mailing list