[Healeys] bending exhaust down pipes

Jackson Krall jackson_krall at yahoo.com
Fri Nov 9 10:26:17 MST 2012


Hello John, I have zero experiance with bending machines but there is a
procedure done w/OA torch called a wrincle bend that might be more
controlable. Make a red hot ring around pipe at the place you want the bend,
place the pipe in a vise or other leveragable position and give it a yank in
direction of needed bend. A slight bulge will appear on inside radius but not
a kink. If more bend is needed, heat another ring next to first and repeat,
etc. I've made decent looking 900 bends this way, not unlike store bought
pipes that have bends with a washboard look.
Best
JK

------------------------------
On Thu, Nov 8, 2012 11:23 PM EST john spaur wrote:

>I need to adjust my pre-shaped exhaust down pipes and I have access to a
hydraulic pipe bender. I have experimented a little and when I bend a pipe it
does not seem to go in the direction I would expect it to go.
>
>Are there any trade secrets or tricks to figuring out how to get a pipe bent
a few degrees in a predictable direction?
>
>Thank you,
>
>John Spaur
>San Jose, CA
>_______________________________________________


More information about the Healeys mailing list