[Healeys] Gas tank bottom seal

[john spaur]

It becomes obvious when you set the seal in place and then the tank 
although you need to remove the tank again if you don't place the fat 
edge against the bulkhead. BTW, I had to put an extra shim piece in 
on the fat side.

John

At 08:45 PM 6/15/2012 -0700, Bob Spidell wrote:
>OK, I know we went over this once, but I can't find it in the 
>archives.  I just got one of the new rectangular foam rubber seals 
>and it's wedge-shaped as viewed from the side.  Anyone know for sure 
>which way it should slope in the car; i.e. skinny edge towards front 
>of car, or rear?
>
>TIA,
>Bob
>
>--
>*******************************************************************
>Bob Spidell           San Jose, CA            bspidell at comcast.net
>
>*******************************************************************
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation  $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys at autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net