[Healeys] Starter Problem - update

[Derek Job]

I have just read up on the Hi-Torque starters and to answer my own question
I believe what I have to do is remove the by-pass wire on the starter motor
and connect the red/white wire from the starter button directly to the
spade connector on the starter starter motor instead of it going to the
solenoid. And then connect the battery cable directly to the starter.

Any thoughts?


Derek

On Thu, Jul 19, 2012 at 7:00 AM, Derek Job <derek.c.job at gmail.com> wrote:

> Hi (started new thread again!)
>
> That is true but my solenoid doesn't have the push button and also I think
> it might be source of my problems  so if I bypass it then it eliminates one
> potential source of failure.
>
>
>
> The hi torque starter has the link wire to the internal solenoid spade
> terminal. I think I leave this in place and presumably connect the cable
> that currently goes to the old solenoid directly to the starter. Does that
> make sense and is there something else I would need to do. Unfortunately my
> go to Healey mechanic is at Silverstone today and i cant get him and I need
> the car tomorrow.
>
>
> All help greatly appreciated
>
> cheers
>
> Derek