[Healeys] Corrected link to my new post.

[Oudesluys]

Hello Michael,
I stand corrected, you are absolutely right. I missed a few steps 
looking down the line for the procedure.
Cheers,
Kees Oudesluijs

Op 2-7-2012 14:44, Michael Salter schreef:
> Hi Kees, I'm not sure how you concluded that I press the impeller on first!
> I would appreciate your checking the post again to see if you still
> conclude that I have the order incorrect.
>
> Michael S
>
> On 2012-07-02, at 3:48 AM, Oudesluys <coudesluijs at chello.nl> wrote:
>
>> I am surprised that you press on the impeller before the bearing itself is pressed into the pump body, that way the ball bearings and races are loaded and possibly damaged when the bearing/impellor assembly is pressed in. This can be a fairly tight fit on many water pumps. I would press in the bearing into the housing first using an apropriate spacer/tube section/old socket and after that press on both the flange and impeller to avoid the possibility of damaging the bearing.
>>
>> If the press fitting of the flange or the impeller is a bit loose you can use some Locktite.
>>
>> Kees Oudesluijs
>>
>>
>> Op 1-7-2012 20:14, Michael Salter schreef:
>>> My apologies about the incorrect link..
>>> This should work.
>>>
>>> Instructions on BJ8 Water Pump Rebuilding
>>>
>>>
>>> http://www.netbug.net/blogmichael/?p=994
>>>
>>>
>>
>> --
>> Kees Oudesluijs
>> Dorpsstraat 183
>> 2995XG Heerjansdam
>> T: 078-677 1233
>> E: coudesluijs at chello.nl
>>
>> Technische commissie Jensen Healey en GT
>> Het Jensen Genootschap Holland
>> www.jensenholland.nl
>>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2012.0.2180 / Virusdatabase: 2437/5105 - datum van uitgifte: 07/01/12
>
>
>


-- 
Kees Oudesluijs
Dorpsstraat 183
2995XG Heerjansdam
T: 078-677 1233
E: coudesluijs at chello.nl

Technische commissie Jensen Healey en GT
Het Jensen Genootschap Holland
www.jensenholland.nl