[Healeys] Smith's Temp Gauge

[BJ8 Healeys]

Bob, I calibrated my gauge just as Kees recommends:  I found it reading 10
degrees too high (kind of explains my "overheating" problem).  Putting the
needle back on so that it was exactly between the two dots at 212 deg.
while the sensor was immersed in boiling water fixed it.

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Bob Spidell
Sent: Sunday, December 30, 2012 1:14 AM
To: healeylist
Subject: [Healeys] Smith's Temp Gauge

Anyone got info on how to calibrate the Smiths temp gauge?  I know about
immersing in boiling water, etc., but I think there might be a couple screws
or a wire to bend or something.

Bob